Issue link: https://aalbadent.uberflip.com/i/107865
C&B C&B Mechanical Properties ACCESSORIES Tensile Strength Yield Strength NPG 81,200 (560) 38,425 (265) NPG+2 79,000 (546) VeraSoft 77,100 (532) Elongation Percent Vickers Hardness Density Color 15 140 7.8 41,500 (286) 16 143 54,700 (377) 14 VeraSoft ES 88,160 43,210 (608) (298) 24 psi (MPa) psi (MPa) % Ceramic Restorations Crown & Bridge Partial Denture Framework Single Units & Multi Unit Bridgework Onlays, Posts & Cores Sub-Structure for Polymer Crown & Bridge Resins Implant Super Structures Maryland Bridge ISO Classification of Properties Registrations & Certifications Melting Range Composition Yellow-Gold 1,850-1,950 (1,012-1,068) Cu 80.7% Al 7.8% Ni 4.3% Fe, Zn, Mn Type 2 FDA, CE, CCq 7.8 Yellow-Gold 1,850-1,949 (1,012-1,065) Cu 78.7% Al 7.8% Au 2% Ni, Fe, Zn, Mn Type 3 FDA, CE, CCq 236 7.7 White 1,994-2,228 (1,090-1,220) Ni 53.6% Mn 19.5% Cr 14.5% Cu, Al, Si, Fe Type 4 FDA, CE, CCq 185 8.5 White 2,075-2,458 (1,135-1,348) Ni 76.5% Cu 11.5% Cr 5.0% Sn, Si Type 3 FDA, CE, CCq HV1 g/cm3 °F (°C) PFM FMC ALBRAL CASTING FLUX AALBA GOLD SOLDER Use Albral Casting Flux when casting Aalba Gold Solder… a premium 585 NPG and NPG+2. Albral Casting Flux low fusing post solder for NPG, will increase fluidity while reducing NPG+2 and gold-based crown and oxide formation. bridge casting alloys. Use Aalba Gold Solder in conjunction with Aalba Flux Packaging for the best results. Aalba Gold Solder 1 dwt (1.55g) packet AALBA FLUX Use Aalba Flux when soldering NPG or Aalba Flux 1.5 oz (42.5g) jar NPG+2 casting alloys. Aalba Flux is a fluoride paste flux. Aalba Flux has no Albral Casting Flux 2 oz (56.7g) jar odor and it can be thinned with distilled water in order to maintain proper consistency. 34 0120 CE 120 Class IIa medical device in compliance with Directive 93/42/ECC License No. 296734; United States of America Department of Health and Human Services Food & Drug Administration (FDA) Aalba Dent products designated with our CCQ mark are Certified by Aalba Dent as continuous cast products from our proprietary state-of-the-art continuous casting technology. Products produced from this process exhibit unparalleled homogeneity, precise alloy chemistry and lower gas content. AalbaDent, Inc. is a registered, medical device manufacturer in compliance with applicable Good Manufacturing Practices Regulations, Federal/State laws, local environmental laws and regulations. Facility license No. 61179; State of California: Department of Health Services: Food & Drug Branch. 35